I’m Wild About Wrap Watches…How About You?

Like the title says, I’m pretty wild about any kind of wrap jewelry so I was super excited to make this wrap watch. If you’re like me and you like wrap jewelry too, go on and grab these items and let’s make one of these little beauties for you too!

I purchased all supplies from Michael’s Craft Supply.

Supplies needed

Watch face with 6 connector ports

6 small jump rings

6 large jump rings

1 clasp

Bead Landing big ring chain in gunmetal

Strand of suede in color of preference

Small beads in color of preference

Glue on crystals

Super Glue

Bead thread

Pliers

Wire cutter

Step 1: Measure your wrist to see how long you want each side to be and how many wraps you want then cut your chain and suede to that size. I have fairly small wrists at 5.5 inches and I wanted the watch to wrap once on each side of the watch face, so I cut the chain, suede and bead thread on both sides at 9 inches. Then run the end of suede through large jump ring and glue it to itself to secure jump ring. Repeat with all 4 ends of sued.

Step 2: Glue crystals 1 inches apart onto suede.

Step 3: Connect chain and suede with small jump rings to the two outer connector ports of the watch base.

Step 4: Connect a small jump ring to the middle connector port of the watch base. Tie a knot with your bead thread to that jump ring and start stringing beads until you reach the same length as your chain and suede. Then repeat on the other side.

Step 5: Once you finish stringing your beads, connect your bead string, suede and chain with a large jump ring. Do the same thing on the other side except add the clasp. And you’re done!

Presto…now you have a new pretty wrap watch.

As always, feel free to leave me a comment here or send me an email if you have any questions.

Thanks for stopping by!

Print this